Collaboration with our clients usually begins with the start of a developmental project or an idea for a new or adjusted product. In one case, ideas are made clear in a simple sketch and in another case, with a worked out product drawing. We handle that creatively and we always work towards an optimal solution. This all happens in the shape of a good product that can be produced efficiently in a synthetic material type that meets your demands and on top of that, which is practical in use. If desired, we can make a stereo lithography, so that you can judge your product in the flesh before the build of the mould begins. For complex products, there is a possibility to build so-called low cost test moulds.

A mould is an obvious necessity for every injection mould. With CAD/CAM software a detailed drawing of your product is made, where after the mould is made. During the designing we make a choice for either a single or multiple moulds based on reduction prognoses. The building of the mould is done under our supervision. If the tool maker is ready and the mould has gotten approval from engineering, it is then handed over to the injection moulder to test it.